Woodworking engraving machine in use, it may occur without suction adsorption countertops, plates unable adsorption phenomenon, which is what causes it, how to solve it? Today to introduce you to the solution engraving machine table is not adsorbed:
1, the motor line voltage is normal;
2, whether to raise water circulation pump less water, whether the motor stuck rusted fence to remove the fan motor rotation axis;
3, vacuum pump filter clogged clean up;
4, table or pipe leakage phenomenon dressing;
5, Reversible replace the motor, any two lines change the motor direction.
Woodworking engraving machine adopts vacuum suction plate fixed, not only can be firmly fixed, mobile sculpture dislocation does not occur, and relatively splint can save plates, carved into the sheet edge, saving time and effort.
1, the motor line voltage is normal;
2, whether to raise water circulation pump less water, whether the motor stuck rusted fence to remove the fan motor rotation axis;
3, vacuum pump filter clogged clean up;
4, table or pipe leakage phenomenon dressing;
5, Reversible replace the motor, any two lines change the motor direction.
Woodworking engraving machine adopts vacuum suction plate fixed, not only can be firmly fixed, mobile sculpture dislocation does not occur, and relatively splint can save plates, carved into the sheet edge, saving time and effort.